View and Download AMMCO installation instructions manual online. Disc Rotor Lathe. Lathe pdf manual download. iv • AMMCO Brake Lathes. Safety. Safety Notices and. Decals. For your safety, and the safety of others, read and understand all of the safety notices and . Get AMMCO Disc Rotor Lathe Manual. Get all AMMCO manuals!.
|Published (Last):||20 February 2004|
|PDF File Size:||13.56 Mb|
|ePub File Size:||18.29 Mb|
|Price:||Free* [*Free Regsitration Required]|
Center the twin cutter to the rotor. Choose one of the inner grooves when machining medium duty truck rotors. Turn both tool bit controls to the desired depth-of-cut and lock them amcmo position. Page 7 Brake Lathes Installation Receiving The shipment should be thoroughly inspected as soon as it is received.
Automotiv e Ser vice Equipment and T ools.
AMMCO PARTS & INFO
The signed bill of lading is AMMCO electrical and electronic based machines are acknowledgement by the carrier of receipt in good con- designed for nominal line voltages with variations of dition of shipment covered by our invoice. Brake Lathes Cross Feed – The cross feed draws the twin tool bits across the face of a brake rotor when the cross feed drive is engaged. Safety Safety Notices and Decals For your safety, and the safety of others, read and understand all of the safety notices and decals included here and on the unit.
This is caused by runout or wobble due to rotor condition or by the way the rotor is mounted on the arbor. Page 14 Turn the left hand tool bit control until the tool bit contacts the rotor surface and makes a scratch cut no deeper than.
What’s missing? Tell us about it.
Loosen the stud nut, Fig. Use the outer pulley aammco for all passenger car and light truck rotors, Fig. Tell us about it. When the cross feed has moved the cutting tools all the way across the face of the rotor, the feed will shut off automatically.
If any of the goods called for on this bill of lading are shorted or damaged, do not accept them until the carrier makes a notation on the freight bill of the shorted or damaged goods. Got it, continue to print. Read entire manual before installing, operating, or servicing this equipment.
Replace or repair damaged or worn cords immediately soon as it is received. Use a micrometer to check the thickness of the rotor at no less than three points around the circumference about 1″ Turn the cross feed handwheel back about a half turn, start the lathe and move the tool bit in to make a second scratch cut. Reconditioning Disc Brake Rotors The patented self-aligning spacer prevents diagonal thrust on the adapters.
Handle the adapters and arbors with care and store them on individual hooks. Move the tool bits inward until they just contact the faces of the rotor. Clean, repair, remount, or replace as necessary.
Chips and dust could be driven between machined parts and into bearings causing undue wear. Either rough or finish cuts may be taken to resurface a rotor.
Use a face shield and dust mask during dusty operations. After the brake rotor is mounted on the arbor, install the silencer band. Turn each tool bit control the outer knurled knobs clockwise until the tool bits just contact the rotor faces.
Keep all guards, shields, and covers in place and in working order. Brake Lathes The scratch will usually appear as an incomplete circle. For additional copies of either, or further information, contact: Page 15 Brake Lathes The scratch will usually appear as an incomplete circle.
Or point us to the URL where the manual is located. Now engage the automatic cross feed by moving the knobFig. Turn the left hand tool bit control until the tool bit contacts the rotor surface and makes a scratch cut no deeper than. Retighten wmmco arbor nut.
Safety glasses, goggles, or a face shield contact persons in the area causing personal injury.